1. Ifihan
This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.
Alaye Aabo
- Do not look directly into the LED light. The intense beam can cause temporary vision impairment.
- Jeki kuro ni arọwọto awọn ọmọde.
- Use only Streamlight approved batteries and charging equipment.
- Do not attempt to disassemble the flashlight head or battery pack.
- Avoid exposing the flashlight to extreme temperatures or corrosive liquids.
Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.
2. Eto
2.1 Ibẹrẹ gbigba agbara batiri
Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.
- Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
- Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
- The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
- Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.
2.2 Battery Installation (if required)
The battery is typically pre-installed. If you need to replace or install the battery:
- Yọ ideri iru ti ina filaṣi naa kuro nipa titan-ni-aago.
- Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
- Yi fila iru pada si ọna aago titi yoo fi di wiwọ ni aabo.
3. Awọn ilana Iṣiṣẹ
The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.
3.1 Agbara Tan / Pa ati Aṣayan Ipo
- Lati tan: Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
- Láti lo àwọn ipò kẹ̀kẹ́: With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
- To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
- Lati paa: Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.
3.2 Recharging the Flashlight
When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.
4. Itọju
4.1 Ninu
- Nu ara ina mànàmáná náà pẹ̀lú ìpolówóamp asọ. Ma ṣe lo abrasive ose tabi epo.
- Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.
4.2 Battery Care and Replacement
- For optimal battery life, avoid fully discharging the battery before recharging.
- If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
- Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.
4.3 Ibi ipamọ
Tọju ina filaṣi naa ni itura, aye gbigbẹ kuro lati orun taara ati awọn iwọn otutu to gaju.
5. Laasigbotitusita
Tọkasi tabili ni isalẹ fun awọn ọran ti o wọpọ ati awọn ojutu wọn.
| Isoro | Owun to le Fa | Ojutu |
|---|---|---|
| Ina filaṣi ko tan. | Battery is depleted or improperly installed. | Recharge the battery. Check battery orientation. Ensure tail cap is tightened. |
| Imọlẹ jẹ baibai tabi flickers. | Low battery charge. Loose connections. | Recharge the battery. Ensure tail cap is tightened. Clean charging contacts. |
| Ina filaṣi ko gba agbara. | Charger not powered. Dirty charging contacts. Faulty battery or charger. | Check power outlet. Clean charging contacts on flashlight and charger. Try a different power source. Contact customer support if issue persists. |
6. Awọn pato
| Ẹya ara ẹrọ | Ẹ̀kúnrẹ́rẹ́ |
|---|---|
| Awoṣe | Stinger LED HL 120/DC PB |
| Orisun Imọlẹ | LED |
| Imọlẹ funfun | 800 Lumens (ti o ga) |
| Orisun agbara | Agbara Batiri |
| Batiri Iru | NiMH (Nickel-Metal Hydride) |
| Nọmba ti awọn batiri | 1 (pẹlu) |
| Ohun elo | Aluminiomu, Irin |
| Àwọ̀ | Buluu |
| Pataki Awọn ẹya ara ẹrọ | Rechargeable, Multiple lighting modes (High, Medium, Low, Strobe) |
| Omi Resistance Ipele | Ko Omi Resistant |
| Iwọn Nkan | 3 iwon |
7. atilẹyin ọja Information
Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight webaaye tabi kaadi atilẹyin ọja ti o wa pẹlu rira rẹ. Jeki ẹri rira rẹ fun awọn iṣeduro atilẹyin ọja.
8. Onibara Support
If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.