Hayward W3H135FDP H-Series Propane Pool Heater User Manual

1. Ifihan

This manual provides essential information for the safe and efficient installation, operation, and maintenance of your Hayward W3H135FDP H-Series Propane Pool Heater. Please read this manual thoroughly before attempting to install or operate the heater. Keep this manual for future reference.

The Hayward H-Series heater is designed for heating above-ground pools using propane gas. It features a durable cupro nickel heat exchanger, an intuitive electronic control panel, and forced-draft combustion for reliable performance in various weather conditions.

Iwaju view of the Hayward W3H135FDP H-Series Propane Pool Heater, highlighting its 135,000 BTU capacity, propane fuel type, and suitability for above-ground pools.

2. Alaye Aabo pataki

IKILO: Fifi sori ẹrọ ti ko tọ, atunṣe, iyipada, iṣẹ, tabi itọju le fa ibajẹ ohun-ini, ipalara, tabi iku. Ka fifi sori ẹrọ, ṣiṣiṣẹ, ati awọn ilana itọju daradara ṣaaju fifi sori ẹrọ tabi ṣiṣẹsin ohun elo yii.

• Ge asopọ agbara nigbagbogbo ṣaaju ṣiṣe.
• Rii daju pe fentilesonu to dara ni ayika ẹrọ igbona.
• Ma ṣe tọju tabi lo epo petirolu tabi awọn ina ina miiran ati awọn olomi ni agbegbe eyi tabi eyikeyi ohun elo miiran.
• Fifi sori ẹrọ ati iṣẹ gbọdọ jẹ ṣiṣe nipasẹ olutọpa ti o peye, ile-iṣẹ iṣẹ, tabi olupese gaasi.
• Yi ti ngbona jẹ apẹrẹ fun propane gas only. Do not attempt to use natural gas.
• Jeki awọn ọmọde ati ohun ọsin kuro ni ẹrọ ti ngbona.

3. Package Awọn akoonu

Verify that all components are present before beginning installation. If any parts are missing or damaged, do not proceed with installation and contact Hayward customer support.

• Hayward W3H135FDP H-Series Propane Pool Heater unit
• Afowoyi Olumulo (iwe-ipamọ yii)
• Installation hardware (specific items may vary, refer to packing list)

4. Eto ati fifi sori

Installation must comply with all local codes and ordinances. In the absence of local codes, refer to the National Fuel Gas Code (ANSI Z223.1/NFPA 54) or the Natural Gas and Propane Installation Code (CSA B149.1).

4.1 Awọn ibeere ipo

• Install the heater outdoors, on a level, non-combustible surface.
• Maintain adequate clearances from combustible materials and other equipment. Refer to the heater's data plate for specific clearance requirements.
• Ensure the location allows for proper ventilation and drainage.
• Avoid locations where the heater may be exposed to excessive wind or spray from the pool.

4.2 Plumbing Awọn isopọ

Connect the heater to your pool's filtration system. The heater should be installed after the filter and before any chemical feeders.

• Use appropriate plumbing fittings and sealants to prevent leaks.
• Ensure proper water flow through the heater. Insufficient flow can cause damage.

Apa view of the heater, illustrating the plumbing inlet/outlet and the forced-draft combustion system.

4.3 Gas Connections (Propane Only)

PATAKI: This heater is factory-set for propane gas. Do not attempt to convert it to natural gas. Gas connections must be made by a qualified professional.

• Connect the propane supply line to the heater's gas inlet.
• Ensure all gas connections are tight and leak-free. Use a leak detection solution to check for leaks.
• Install a manual gas shut-off valve upstream of the heater.

4.4 Electrical Awọn isopọ

Electrical wiring must be performed by a qualified electrician in accordance with all local codes and the National Electrical Code (NFPA 70).

• Rii daju pe ẹrọ igbona ti wa ni ilẹ daradara.
• Connect the heater to a dedicated circuit with appropriate overcurrent protection.

5. Awọn ilana Iṣiṣẹ

5.1 Ibẹrẹ Ibẹrẹ

1. Ensure the pool pump is running and there is adequate water flow through the heater.
2. Open the manual gas shut-off valve to supply propane to the heater.
3. Turn on the electrical power to the heater.
4. The electronic control panel will illuminate.

5.2 Setting Desired Temperature

Use the intuitive electronic control panel to set your desired pool temperature.

1. Press the "Mode" button to select the pool heating function.
2. Use the up/down arrow buttons to adjust the target temperature.
3. The heater will automatically ignite and begin heating the water to the set temperature.

The electronic control panel for setting and monitoring pool temperature.

5.3 Tiipa Agbona

1. To temporarily stop heating, turn off the heater via the control panel.
2. For extended shutdown or servicing, close the manual gas shut-off valve and turn off the electrical power to the heater.

6. Itọju

Regular maintenance ensures optimal performance and longevity of your Hayward H-Series heater. Always disconnect power and gas supply before performing any maintenance.

6.1 Awọn sọwedowo baraku

• Oṣooṣu: Inspect the area around the heater for debris, obstructions, or signs of leaks.
• Seasonally: Check the heat exchanger for scale buildup or corrosion. If necessary, clean according to manufacturer guidelines or consult a qualified service technician.
• Ensure proper water chemistry in your pool to prevent damage to the heater's components.

6.2 Igba otutu

In areas subject to freezing temperatures, proper winterization is crucial to prevent damage.

1. Turn off the heater and disconnect both electrical power and gas supply.
2. Drain all water from the heater's plumbing and heat exchanger. Use a shop vacuum or air compressor to ensure all water is removed.
3. Store the heater in a dry, protected area if possible, or cover it with a weather-resistant cover.

7. Laasigbotitusita

Ṣaaju ki o to kan si atilẹyin alabara, tunview awọn wọnyi wọpọ oran ati awọn solusan.

If troubleshooting steps do not resolve the issue, contact Hayward customer support or a qualified service professional.

8. Awọn pato

• Awoṣe: W3H135FDP
• Iru epo: Gaasi Propane
• Iṣawọle BTU: 135,000 BTU / wakati
• Imudara Ooru: 82%
• Oluyipada Ooru: Cupro Nickel
• Awọn iwọn (L x W x H): Isunmọ 30.3 x 21.4 x 22.6 inches (77 x 54.4 x 57.4 cm)
• Ìwọ̀n Nkan: Isunmọ 117.5 lbs (53.3 kg)
• Awọn ibeere Itanna: Tọkasi aami ọja fun voltage ati ampigba.
• Awọn itujade NOx: Low NOx (meets clean air quality standards)

Product dimensions and weight for the Hayward W3H135FDP H-Series Pool Heater.

Orisirisi views of the Hayward W3H135FDP H-Series Pool Heater, illustrating its design from different angles.

9. Atilẹyin ọja ati Support

Hayward provides a limited warranty for its products. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Hayward webojula.

For technical assistance, parts, or service, please contact Hayward customer support:

• Webojula: www.hayward.com
• Foonu: Refer to the Hayward webAaye fun agbegbe awọn nọmba olubasọrọ.

When contacting support, please have your model number (W3H135FDP) and serial number ready.