ECOELER YWT102 4-Hour Countdown Timer Switch

Ọrọ Iṣaaju

Thank you for choosing the ECOELER YWT102 4-Hour Countdown Timer Switch. This device is designed to provide convenient and energy-efficient control over your lights, fans, and other household appliances by automatically turning them off after a set period. Please read this manual thoroughly before installation and operation to ensure proper use and safety.

Ọja Awọn ẹya ara ẹrọ

• 8 Pre-Set Countdown Options: Select from 1 min, 5 mins, 10 mins, 15 mins, 30 mins, 60 mins, 2 hours, or 4 hours.
• Manual ON/OFF Override: Easily override any countdown setting for instant control.
• Ifipamọ Agbara: Automatically turns off connected loads, preventing accidental energy waste.
• Isẹ ti o rọrun: Features a Countdown mode and a Constant On mode.
• Atọka LED: A blue LED light indicates the selected time and makes the switch easy to locate in the dark.
• Ohun elo jakejado: Suitable for lights, ceiling fans, bathroom fans, and heaters in various rooms like bathrooms, closets, pantries, garages, and laundry rooms.
• Awọn iwe-ẹri Abo: ETL listed, supporting LED/CFL, Incandescent (800W), Fluorescent (1200VA) light bulbs, and motors (1/2 HP).

Alaye Aabo

• IKILO: Láti yẹra fún iná, ìpayà, tàbí ikú, pa agbára ní ibi tí ẹ̀rọ ìfọ́mọ́ tàbí àpótí fiusi wà kí o sì dán an wò pé agbára náà ti pa kí o tó fi wáyà sí i.
• Fi sori ẹrọ ni ibamu pẹlu gbogbo awọn koodu itanna ti orilẹ-ede ati ti agbegbe.
• Use only with copper or copper clad wire.
• This device requires a neutral wire for operation. If your switch box does not have a neutral wire, this product is not compatible.
• Do not exceed the maximum load ratings: 15A, 120V AC, 60Hz. Incandescent: 800W, Fluorescent: 1200VA, LED/CFL: 600W, Motor: 1/2 HP.

Fifi sori ẹrọ

Follow these steps carefully for safe and correct installation:

1. Pa Agbara: Locate the circuit breaker or fuse that controls the switch you are replacing and turn it off. Verify that the power is off using a voltage idanwo.
2. Yọ Yipada atijọ kuro: Carefully remove the existing wall plate and switch from the electrical box. Disconnect the wires from the old switch.
3. Ṣe idanimọ Awọn okun: Identify the following wires in your electrical box:
   • Load Wire (Red): Connects to the light or fan.
   • Hot Wire (Black): Incoming power from the circuit breaker.
   • Wáyà Dídúró (Fúúfù): Required for this timer switch.
   • Ground Wire (Green/Bare Copper): Fún ààbò.
4. So Aago Yipada: Use the provided wire nuts to connect the wires from the electrical box to the corresponding wires on the ECOELER timer switch.
   • Sopọ awọn Pupa wire from the timer to the Fifuye wire from the box.
   • Sopọ awọn Dudu wire from the timer to the Gbona wire from the box.
   • Sopọ awọn Funfun wire from the timer to the Àdánù wire from the box.
   • Sopọ awọn Alawọ ewe wire from the timer to the Ilẹ wire from the box.
5. Gbe Iyipada naa: Carefully push the wired switch into the electrical box. Secure it with the mounting screws.
6. Fi Awo Odi sori ẹrọ: Attach the included wall plate.
7. Pada Agbara pada: Tan agbara pada si ẹrọ fifọ.

Isẹ

The ECOELER YWT102 timer switch offers two primary modes of operation: Countdown Mode and Constant On Mode.

Ipo Kika

This mode allows you to set the connected load to turn off automatically after a specified duration.

1. Yan Akoko: Press the "Timer Select Button" (up/down arrows) to cycle through the available countdown options: 1 min, 5 mins, 10 mins, 15 mins, 30 mins, 60 mins, 2 hours, or 4 hours. The corresponding LED indicator will light up.
2. Bẹ̀rẹ̀ kíkà ìsàlẹ̀: Press the large "Manual ON/OFF" button once. The connected light or fan will turn on, and the countdown will begin. The timer will remember the last selected time for future use.
3. Cancel Countdown: To turn off the load before the countdown completes, press the "Manual ON/OFF" button again.

Constant On Mode (Manual Override)

This mode keeps the connected load continuously on, bypassing the countdown timer.

• Activate Constant On: With the load off, press and hold the "Manual ON/OFF" button for more than 5 seconds. The load will turn on and remain on indefinitely.
• Deactivate Constant On: To turn off the load from Constant On mode, press the "Manual ON/OFF" button once.

Awọn pato

Laasigbotitusita

Itoju

The ECOELER YWT102 Countdown Timer Switch requires minimal maintenance. To ensure longevity and proper function:

• Ninu: Wipe the switch and wall plate with a soft, damp asọ. Ma ṣe lo abrasive ose tabi epo.
• Awọn iṣayẹwo deede: Periodically check for any loose connections or signs of wear. If any issues are found, turn off power at the circuit breaker before inspecting.

Atilẹyin ọja ati Support

Atilẹyin ọja: Ọja yii wa pẹlu atilẹyin ọja ọdun kan lati ọjọ rira.

Atilẹyin Onibara: If you have any questions, require assistance, or encounter issues with your ECOELER Countdown Timer Switch, please contact ECOELER ELECTRIC INC customer support.

Imeeli: SUPPORTS@ECOELER.COM