Ọrọ Iṣaaju
This manual provides instructions for the proper installation, operation, and maintenance of the LASCO 10-2431 Braided Vinyl Water Supply Line. This product is designed to connect most faucets to a water source, ensuring a reliable and lead-free connection.
The LASCO 10-2431 is a 1/2-inch Female Iron Pipe (FIP) by 1/2-inch Female Iron Pipe (FIP) by 30-inch flexible braided vinyl supply line. It is certified by the Uniform Plumbing Code (UPC) and meets California AB-1953, Vermont, and new federal standards for low lead applications, ensuring product quality and safety.
Image showing the LASCO 10-2431 braided vinyl water supply line, featuring its flexible design and connection ends.
Alaye Aabo
- Pa ipese omi akọkọ nigbagbogbo ṣaaju ki o to bẹrẹ eyikeyi iṣẹ iwẹ.
- Wọ ohun elo aabo ti ara ẹni ti o yẹ, gẹgẹbi awọn gilaasi aabo, lakoko fifi sori ẹrọ.
- Do not over-tighten connections, as this can damage the supply line or fittings.
- Rii daju pe gbogbo awọn asopọ wa ni aabo lati ṣe idiwọ awọn n jo.
- This product is designed for water supply applications only. Do not use for gas or other non-water applications.
- The product is lead-free and complies with California AB-1953, Vermont, and federal low lead standards.
Package Awọn akoonu
- 1 x LASCO 10-2431 Braided Vinyl Water Supply Line (1/2-Inch FIP x 1/2-Inch FIP x 30-Inch)
Eto ati fifi sori
Follow these steps to properly install your LASCO 10-2431 water supply line:
- Ṣetan Agbegbe: Turn off the main water supply to the area where the installation will take place. Drain any residual water from the existing lines.
- Remove Old Supply Line (if applicable): Use an adjustable wrench to carefully disconnect the old supply line from both the faucet and the water stop valve. Have a bucket ready to catch any remaining water.
- Ṣayẹwo awọn isopọ: Ensure that the threads on both the faucet shank and the water stop valve are clean and free of debris.
- Sopọ mọ Faucet: Hand-tighten one end of the LASCO 10-2431 supply line to the faucet shank. Once hand-tight, use an adjustable wrench to tighten an additional 1/4 to 1/2 turn. Do not over-tighten.
- Connect to Water Stop Valve: Hand-tighten the other end of the supply line to the water stop valve. Once hand-tight, use an adjustable wrench to tighten an additional 1/4 to 1/2 turn. Do not over-tighten.
- Ṣayẹwo fun awọn Kinks: Ensure the supply line is not kinked or bent sharply, which could restrict water flow or damage the line.
- Mu Ipese Omi pada: Laiyara tan ipese omi akọkọ.
- Ṣayẹwo fun awọn n jo: Carefully check all connections for any signs of leaks. If a leak is detected, turn off the water supply, tighten the connection slightly, and recheck.
Awọn ilana Iṣiṣẹ
Once installed, the LASCO 10-2431 water supply line operates passively to deliver water. Ensure the water supply is fully turned on at the stop valve and the main supply. Monitor for consistent water flow and absence of leaks, especially during the first few hours after installation.
Itoju
- Ayewo Igbakọọkan: Periodically inspect the supply line for any signs of wear, corrosion, kinks, or leaks. It is recommended to check connections annually.
- Ninu: The exterior of the braided vinyl can be wiped clean with a damp aṣọ tí ó bá pọndandan. Má ṣe lo àwọn kẹ́míkà líle tàbí àwọn ohun ìfọmọ́ tí ó máa ń pa ara.
- Rọpo: If any damage or persistent leaks are observed, replace the supply line immediately with a new, compatible unit.
Laasigbotitusita
| Isoro | Owun to le Fa | Ojutu |
|---|---|---|
| Jíjó ní ojú ọ̀nà ìsopọ̀mọ́ra | Loose connection, damaged washer, cross-threaded fitting | Turn off water supply. Gently tighten connection. If leak persists, disconnect, inspect washer for damage, and ensure threads are aligned before re-tightening. Replace if necessary. |
| Ṣiṣan omi kekere | Kinked supply line, partially closed stop valve, debris in line | Check the supply line for kinks and straighten if found. Ensure the water stop valve is fully open. If problem persists, the line may need to be inspected for internal debris or replaced. |
| Visible damage to line | Physical impact, excessive bending, age-related wear | Turn off water supply immediately. Replace the damaged supply line with a new one. |
Awọn pato
- Nọmba awoṣe: 10-2431
- Brand: LASCO
- Ohun elo: Braided Poly Vinyl
- Awọn isopọ: 1/2-Inch Female Iron Pipe (FIP) x 1/2-Inch Female Iron Pipe (FIP)
- Gigun: 30 inches
- Àwọ̀: Silver/Pewter
- Awọn iwe-ẹri: Uniform Plumbing Code (UPC) certified, Lead-Free (meets California AB-1953, Vermont, and new federal standards)
- Ìwọ̀n Nkan: Nǹkan bí 5.4 ounces (0.34 Pounds)
Atilẹyin ọja ati Support
For specific warranty information regarding your LASCO 10-2431 Braided Vinyl Water Supply Line, please refer to the documentation provided at the time of purchase or contact LASCO customer support directly. General product support and technical assistance can be obtained through the manufacturer's official channels.
Olupese: LASCO
Webojula: www.lascofittings.com (Eksample link, verify actual manufacturer webaaye)
Iṣẹ onibara: Refer to manufacturer's webaaye fun awọn alaye olubasọrọ.
