Ọrọ Iṣaaju
This manual provides detailed instructions for the setup, operation, maintenance, and troubleshooting of your FAAC TM2 433DS Remote Control Garage Door Opener. Please read this manual thoroughly before using the device to ensure proper function and longevity.
Eto ati siseto
1. Fifi sori batiri
The FAAC TM2 433DS remote control requires two Lithium batteries, which are typically included. To install or replace batteries:
- Ṣí iṣakoso latọna jijin pẹlu iṣọra casing. This may involve removing a small screw or gently prying open the two halves.
- Wa yara batiri naa.
- Insert the two Lithium batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
- Ti iṣakoso latọna jijin de casing ni aabo.
2. Programming the Remote Control (DIP Switches)
The FAAC TM2 433DS remote control uses DIP switches for programming. To program your new remote, you will need to match the DIP switch settings of an existing, working remote or your garage door opener receiver.
Ti abẹnu view of FAAC TM2 433DS remote control. This image displays the internal components of the FAAC TM2 433DS remote control. Visible are the circuit board, the battery compartment, and a set of DIP switches, which are used for programming the remote to your garage door opener.
- Ṣii casing of your new FAAC TM2 433DS remote control.
- Locate the bank of small switches, known as DIP switches, on the circuit board.
- If you have an existing, working remote: Open its casing and observe the position of its DIP switches (ON/OFF or 1/0).
- If you are programming directly from the receiver: Refer to your garage door opener's manual to locate its DIP switches and note their positions.
- Carefully adjust the DIP switches on your new FAAC TM2 433DS remote control to exactly match the settings of the existing remote or receiver. Use a small, non-conductive tool if necessary.
- Once the DIP switches are set, close the remote control casing ni aabo.
- Test the remote control to ensure it operates your garage door opener correctly.
Akiyesi: If your garage door opener does not use DIP switches, or if you encounter difficulties, consult your garage door opener's specific programming instructions or contact a qualified technician.
Awọn ilana Iṣiṣẹ
The FAAC TM2 433DS remote control features two buttons for operation.
- Ṣíṣí/títì ilẹ̀kùn gáréèjì: Press one of the two buttons on the remote control. The garage door will begin to open or close. Pressing the button again during operation will typically stop the door. A third press will reverse its direction.
- Ibiti: The maximum effective range for this remote control is approximately 10 meters. Ensure you are within this range for reliable operation. Obstructions can reduce the effective range.
Ensure there are no obstructions in the path of the garage door before and during operation to prevent damage or injury.
Itoju
Batiri Rirọpo
If the remote control's range decreases significantly or it stops responding, the batteries may need replacement. Refer to the "Battery Installation" section under Setup for detailed instructions. Always use two new Lithium batteries of the specified type.
Ninu
Clean the remote control's exterior with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the casing or internal components. Avoid exposing the remote to excessive moisture.
Laasigbotitusita
| Isoro | Owun to le Fa | Ojutu |
|---|---|---|
| Isakoṣo latọna jijin ko ṣiṣẹ. |
|
|
| Dinku ibiti o ṣiṣẹ. |
|
|
| Garage door opens/closes intermittently. |
|
|
If these troubleshooting steps do not resolve the issue, contact customer support or a qualified technician.
Awọn pato ọja
| Brand | FAAC |
| Orukọ awoṣe | TM433DS |
| Nọmba awoṣe | TM433DS-2 |
| Ọja Mefa | 0.7 x 0.5 x 0.2 cm |
| Iwọn | 40 giramu |
| ASIN | B008DRDV1W |
| Supported Devices Quantity | 2 |
| Awọn ẹrọ ibaramu | Garage ilekun |
| Asopọmọra Technology | Igbohunsafẹfẹ Redio |
| Bọtini opoiye | 2 |
| Adarí Iru | Iṣakoso bọtini |
| Ibiti o pọju | 10 mita |
| Awọn batiri ti a beere | 2 Lithium (included) |
Alaye atilẹyin ọja
Specific warranty details for the FAAC TM2 433DS remote control may vary by region and retailer. Please retain your proof of purchase for any warranty claims. For detailed warranty terms and conditions, refer to the documentation provided with your purchase or visit the official FAAC webojula.
Onibara Support
For technical assistance, troubleshooting beyond this manual, or inquiries regarding your FAAC TM2 433DS remote control, please contact FAAC customer support or your authorized dealer. Contact information can typically be found on the manufacturer's webojula tabi lori rẹ ra iwe.
- Awọn orisun Ayelujara: Visit the official FAAC website for FAQs, additional manuals, and support contact details.
- Awọn oniṣowo ti a fun ni aṣẹ: Your local FAAC dealer can provide expert advice and service.
