Ọrọ Iṣaaju
This manual provides instructions for the installation, operation, and maintenance of your SOMFY Situo RTS Pure radio wall transmitter. This device is designed for the manual control of one or more radio-controlled Somfy drives, such as blinds, awnings, or roller shutters. Please read this manual carefully before using the product to ensure safe and correct operation.
Awọn Itọsọna Aabo
- Jeki ẹrọ naa kuro lati ọrinrin ati awọn iwọn otutu to gaju.
- Ma ṣe gbiyanju lati ṣii tabi tun ẹrọ naa funrararẹ. Tọkasi gbogbo iṣẹ si oṣiṣẹ oṣiṣẹ.
- Ensure the battery is inserted correctly according to polarity markings.
- Sọ awọn batiri ti a lo ni ifojusọna ni ibamu si awọn ilana agbegbe.
- Ẹrọ yii jẹ ipinnu fun lilo inu ile nikan.
Ọja Pariview
The SOMFY Situo RTS Pure is a sleek, handheld radio transmitter designed for intuitive control of your Somfy RTS products.
Aworan yii fihan iwaju view of the SOMFY Situo RTS Pure radio wall transmitter. It is a white, rectangular device with three gray circular buttons arranged vertically in the center: an 'up' arrow, a 'my' button, and a 'down' arrow. Below the buttons, there is a small black indicator light. The Somfy logo is subtly embossed at the bottom.
Awọn eroja pataki:
- Bọtini oke (^): Moves the connected drive upwards (e.g., opens blinds).
- My Button (my): Stops the drive or recalls a pre-programmed favorite position.
- Bọtini isalẹ (v): Moves the connected drive downwards (e.g., closes blinds).
- Imọlẹ Atọka: Provides visual feedback on commands and battery status.
- Programming Button (rear): Used for pairing the transmitter with Somfy RTS drives.
Ṣeto
1. Fifi sori batiri
- Gently slide open the battery compartment cover on the back of the transmitter.
- Insert the supplied battery (type CR2430) ensuring correct polarity (+/-).
- Pa ideri batiri naa ni aabo.
2. Pairing with a Somfy RTS Drive
To control a Somfy RTS drive, the transmitter must first be paired. This process typically involves using an existing paired transmitter or the drive's programming button.
- Using an existing transmitter: Take an already programmed RTS transmitter that controls the desired drive. Press and hold its programming button (usually on the back) until the drive moves briefly.
- Immediately after the drive moves, take your new Situo RTS Pure transmitter. Press and hold its programming button (located on the back, often recessed) until the drive moves briefly again. This confirms successful pairing.
- Without an existing transmitter: Refer to the specific instructions for your Somfy RTS drive to put it into programming mode. Once the drive is in programming mode, press the programming button on your Situo RTS Pure transmitter until the drive moves briefly.
Note: If you are pairing with multiple drives, repeat the process for each drive or group of drives.
Awọn ilana Iṣiṣẹ
Iṣakoso ipilẹ:
- To move the drive up (e.g., open blinds), press the ^ bọtini.
- To move the drive isalẹ (e.g., close blinds), press the v bọtini.
- Si Duro the drive at any point, press the my bọtini.
Setting a Favorite Position ('my' position):
- Move the drive to your desired favorite position using the ^ or v awọn bọtini.
- Once at the desired position, press and hold the my button until the drive moves briefly. This saves the position.
Recalling a Favorite Position:
- From any position, a short press of the my button will move the drive to its pre-programmed favorite position.
Itoju
Rirọpo Batiri:
When the indicator light on the transmitter no longer illuminates or the range decreases significantly, it is time to replace the battery.
- Slide open the battery compartment cover on the back of the transmitter.
- Yọ batiri CR2430 atijọ kuro.
- Insert a new CR2430 battery, observing the correct polarity (+/-).
- Pa ideri iyẹwu batiri naa.
Note: Dispose of old batteries according to local environmental regulations.
Ninu:
Clean the transmitter with a soft, dry cloth. Do not use abrasive cleaners or solvents.
Laasigbotitusita
| Isoro | Owun to le Fa | Ojutu |
|---|---|---|
| Olùgbéjáde kò dáhùn. | Batiri ti o ku. | Rọpo batiri naa. |
| Dinku ibiti o ṣiṣẹ. | Low battery or radio interference. | Replace battery. Check for sources of interference (e.g., large metal objects, other radio devices). |
| Drive does not respond after pairing. | Pairing unsuccessful or drive is not powered. | Repeat the pairing process. Ensure the drive has power. |
Awọn pato
- Awoṣe: Situo RTS Pure
- Nọmba Awoṣe Olupese: 322147
- Brand: Somfy
- Igbohunsafẹfẹ Redio: 433.42 MHz
- Rolling Code System: Bẹẹni
- Ibiti: Approximately 20 meters (indoors, depending on environment)
- Iru Batiri: CR2430 (pẹlu)
- Awọn iwọn: 1 x 1 x 1 cm (approximate, as per product data); 60 grams
- Lilo ti a pinnu: Ninu ile
Atilẹyin ọja ati Support
For warranty information and technical support, please refer to the official Somfy website or contact your local Somfy dealer. Keep your proof of purchase for warranty claims.
Awọn orisun Ayelujara: www.somfy.com
