LASCO 24V Heat Only Thermostat

Ìwé Ìtọ́sọ́nà fún Thermostat White Rodgers 24V Heat Only

Model: 24V Heat Only Thermostat

1. Ifihan

This manual provides comprehensive instructions for the installation, operation, and maintenance of your White Rodgers 24V Heat Only Thermostat. This device is designed to control heating systems by maintaining a desired temperature within a range of 50 to 90 degrees Fahrenheit (10 to 32 degrees Celsius). Please read these instructions carefully before proceeding with installation or operation to ensure safe and efficient use.

2. Alaye Aabo

Nigbagbogbo ṣe akiyesi awọn iṣọra aabo wọnyi:

  • Ewu Itanna: Disconnect power to the heating system at the main fuse or circuit breaker panel before installing or servicing the thermostat. Failure to do so may result in electrical shock or equipment damage.
  • Voltage ibamu: This thermostat is designed for 24V heating systems only. Do not use it with line voltage (120V or 240V) systems.
  • Fifi sori Ọjọgbọn: If you are unfamiliar with electrical wiring, it is recommended to have a qualified electrician or HVAC technician install this thermostat.
  • Sisọnu Todara: Dispose of old thermostats and packaging materials according to local regulations.

3. Fifi sori ẹrọ ati Oṣo

Tẹle awọn igbesẹ wọnyi fun fifi sori ẹrọ to dara:

3.1 Iṣagbesori Location

Install the thermostat on an inside wall, approximately 5 feet (1.5 meters) above the floor. Avoid locations:

  • Near windows, outside doors, or vents.
  • Near heat-generating appliances (e.g., televisions, lamps, refrigerators).
  • In direct sunlight or areas with poor air circulation.

3.2 Onirin

Before wiring, ensure power to the heating system is OFF.

  1. Remove the cover of the old thermostat and note the wire connections. Typically, a heat-only system will have two wires: 'R' (power) and 'W' (heat call).
  2. Disconnect the wires from the old thermostat.
  3. Mount the new White Rodgers thermostat base to the wall using the provided screws.
  4. Connect the 'R' wire to the 'R' terminal and the 'W' wire to the 'W' terminal on the new thermostat. Ensure connections are secure.
  5. Rọpo ideri thermostat.

3.3 Ibẹrẹ Agbara-soke

Restore power to the heating system at the main fuse or circuit breaker panel. The thermostat is now ready for operation.

White Rodgers Heat Only Thermostat with temperature dial and OFF/ON switch

Nọmba 1: Iwaju view of the White Rodgers Heat Only Thermostat. The upper slider controls the OFF/ON function, while the lower slider sets the desired temperature, indicated in both Fahrenheit (50-90) and Celsius (10-32).

4. Awọn ilana Iṣiṣẹ

The White Rodgers Heat Only Thermostat features simple manual controls.

4.1 Iṣakoso agbara

The upper slider on the thermostat controls the power to the heating system:

  • Gbe si PAA: Disables the heating system.
  • Gbe si ON: Enables the heating system to operate based on the set temperature.

4.2 Ṣiṣeto iwọn otutu

The lower slider on the thermostat is used to set your desired room temperature:

  1. Ensure the upper slider is set to ON.
  2. Move the lower slider to the desired temperature setting. The scale indicates temperatures in both Fahrenheit (50-90°F) and Celsius (10-32°C).
  3. The heating system will activate when the room temperature falls below your set point and will turn off when the room temperature reaches or exceeds your set point.

5. Itọju

This thermostat requires minimal maintenance.

  • Ninu: Lorekore nu awọn ode ti awọn thermostat pẹlu asọ, damp asọ. Ma ṣe lo abrasive ose tabi epo.
  • Yiyọ eruku kuro: Gently remove any dust accumulation from the vents or internal components using a soft brush or compressed air. Ensure power is off before cleaning internal components.
  • This model does not require battery replacement as it is a mechanical, 24V wired thermostat.

6. Laasigbotitusita

If you encounter issues with your thermostat, refer to the following table:

IsoroOwun to le FaOjutu
Ko si ooru
  • Thermostat set to OFF.
  • Ṣeto iwọn otutu ju kekere.
  • Ti fẹ fiusi tabi tripped Circuit fifọ.
  • Alailowaya onirin.
  • Alapapo eto aiṣedeede.
  • Set thermostat to ON.
  • Increase set temperature above room temperature.
  • Check and replace fuse or reset breaker.
  • Check wiring connections (ensure power is OFF).
  • Kan si onimọ-ẹrọ HVAC kan.
Kika iwọn otutu ti ko pe
  • Ipo iwọn otutu ti o kan nipasẹ awọn iyaworan tabi awọn orisun ooru.
  • Ikojọpọ eruku.
  • Relocate thermostat if possible, or shield from drafts/heat sources.
  • Clean thermostat (ensure power is OFF).
Heating system runs continuously
  • Thermostat ṣeto ga ju.
  • Thermostat aiṣedeede.
  • Iwọn otutu ti a ṣeto ni isalẹ.
  • If problem persists, contact an HVAC technician.

7. Awọn pato

  • Brand: White Rodgers (Manufactured by LASCO)
  • Awoṣe: 24V Heat Only Thermostat
  • Voltage: 24 Volts
  • Lọwọlọwọ: 1.2 Amps
  • Iwọn otutu: 50 si 90°F (10 si 32°C)
  • Iru ifihan: Slider Afowoyi
  • Iru Iṣakoso: Button Control (Slider)
  • Imọlẹ ẹhin: Rara
  • Awọn iwọn: Approximately 20 x 7 x 8.8 inches (Product packaging dimensions, actual unit smaller)
  • Ìwọ̀n Nkan: 6.4 iwon
  • UPC: 786710545658

8. Atilẹyin ọja ati Support

Specific warranty information for this White Rodgers thermostat is not provided in the product details. For warranty claims or technical support, please refer to the contact information provided with your purchase or visit the official White Rodgers webAaye ayelujara. Pa ẹri rira rẹ mọ fun eyikeyi ibeere ti o ni ibatan si atilẹyin ọja.

Awọn iwe aṣẹ ti o jọmọ - 24V Heat Only Thermostat

Ṣaajuview Àkọsílẹ̀ Àwọn Igi Ceramic Co. Larsen Supply Co.
Àkójọpọ̀ gbogbogbò ti àwọn igi ìfọṣọ seramiki àti àwọn ẹ̀yà àtúnṣe tó jọra láti ọ̀dọ̀ Larsen Supply Co. (LASCO), tí ó ní àwọn àlàyé pàtó, àwọn nọ́mbà àwòṣe, àti ìwífún ìbáramu fún onírúurú àwọn ilé iṣẹ́.
Ṣaajuview Braeburn 2020NC Thermostat Eto Eto - Awọn ẹya ati Awọn pato
Alaye ni kikun lori Braeburn 2020NC nikan-stage ooru/itura mora tabi ooru fifa ti eto thermostat, pẹlu awọn ẹya ara ẹrọ, ayaworan ati ọja ni pato, ati ibamu.
Ṣaajuview White Rodgers 1F79 Non-Programmable Heat Pump Thermostat Installation Instructions
Comprehensive installation guide for the White Rodgers 1F79 non-programmable heat pump thermostat, covering wiring, mounting, and operation for heating and air conditioning systems.
Ṣaajuview White Rodgers Blue Single 1/1 Stage Thermostat Installation and Operating Instructions
This document provides installation and operating instructions for the White Rodgers Blue Single 1/1 Stage Thermostat, models 1F80-0471 and 1F86-0471. It covers applications, specifications, installation steps, thermostat operation, programming, and troubleshooting.
Ṣaajuview White-Rodgers 1F95-0671 Universal Thermostat Installation and Operation Guide
Comprehensive installation and operating instructions for the White-Rodgers 1F95-0671 Universal Thermostat. Learn about its features, applications, specifications, wiring, programming, and troubleshooting.
Ṣaajuview White Rodgers 1F95EZ-0671 Thermostat Installation and User Guide
Comprehensive installation, configuration, and user guide for the White Rodgers 1F95EZ-0671 thermostat. Learn how to install, wire, program, and troubleshoot your thermostat for optimal heating and cooling control.