Ọja Pariview
The DIRECTV RC73 IR/RF Remote Control is designed for seamless control of your DIRECTV Genie system and other compatible devices. It features both Infrared (IR) and Radio Frequency (RF) technologies, allowing for flexible operation without needing to point the remote directly at the receiver when in RF mode. This remote offers a streamlined layout with essential buttons for navigating your entertainment.
Image: Two DIRECTV RC73 remote controls, showcasing their black and white design and button layout.
Ṣeto
1. Fifi sori batiri
Your DIRECTV RC73 remote control requires two AA batteries for operation. These batteries are typically included with your purchase.
- Wa ideri iyẹwu batiri ni ẹhin isakoṣo latọna jijin.
- Slide the cover downwards or press the release tab (if present) and lift the cover off.
- Insert two AA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the indicators inside the compartment.
- Rọpo ideri iyẹwu batiri, yiya pada si aaye titi yoo fi tẹ ni aabo.
Image: Two DIRECTV RC73 remote controls shown with two AA batteries and a small instruction guide, illustrating the contents of the package.
2. Pairing the Remote to Your DIRECTV Genie Receiver (RF Mode)
To enable RF (Radio Frequency) control, allowing you to operate your receiver without direct line-of-sight, follow these steps:
- Point the remote at your DIRECTV receiver.
- Nigbakannaa tẹ mọlẹ IKU bọtini ati awọn Yan button on the remote for approximately 5 seconds.
- Release the buttons when the green light on the remote blinks twice.
- Using the number pad on the remote, enter the code 961.
- Tẹ awọn CHANNEL UP bọtini lẹẹkan.
- Tẹ awọn WOLE button (located below the number pad).
- Observe your TV screen. A message should appear indicating "Applying RF/IR Setup. Please Wait..." followed by "Your Remote is now setup for RF."
- Tẹ awọn Yan (OK) button on the remote to confirm.
3. Programming the Remote to Your TV (Volume Control)
To control your TV's volume and power with the RC73 remote, you need to program it to your television. This process typically involves selecting your TV's brand from the receiver's menu.
- Tẹ awọn Akojọ button on your DIRECTV remote.
- Navigate down using the Ikanni isalẹ button to find and select Eto.
- Once in Settings, use the directional arrows to navigate to the right until you find and select Isakoṣo latọna jijin.
- From the Remote Control Setup menu, select Bata / Eto jijin.
- Yan Program Audio Device.
- You will be prompted to select your TV's brand. Use the keypad or navigate through the list to find your brand (e.g., Samsung). If you don't know the specific model, select "I don't know my model" if available.
- Follow the on-screen prompts to test the code. This usually involves pressing the AGBARA button on the remote to see if your TV turns off.
- If the TV turns off, select "It Worked" to confirm the programming. If not, select "Try Next Code" and repeat the test until a working code is found.
Awọn ilana Iṣiṣẹ
The DIRECTV RC73 remote control features a user-friendly layout for intuitive navigation and control of your DIRECTV system and connected devices.
Image: A detailed diagram of the RC73 remote, illustrating the function of each button for comprehensive control.
| Bọtini | Išẹ |
|---|---|
| ON/OFF (RC73) | Turns both DIRECTV Receiver and TV ON or OFF at the same time. (Remote must be programmed for TV; HD DVR still records when off.) |
| ITOJU | Press once for On-Screen Guide. Press twice for programming grouped into categories. |
| Akojọ | Accesses the main menu for settings, recordings, and more. |
| AKOSO | Displays the LIST of your recorded programs. |
| JADE | Exits the current menu and returns to the previous channel viewed. |
| Yan | Selects the item highlighted on screen. |
| ALAYE | Displays INFORMATION about the program now playing or highlighted in the On-Screen Guide. |
| VOL (Iwọn didun) | Adjusts the volume of your TV or audio device (if programmed). |
| CH (ikanni) | Iyipada ikanni soke tabi isalẹ. |
| PREV | Returns to the PREVIOUS channel viewed. |
| RECORD (Red Circle) | Records the program now playing or highlighted in the On-Screen Guide. Press twice to record the entire series. |
| IKU | Pa ohun naa di. |
| SISISE | Replays the previous six seconds. |
| TUNTUN | Rewinds at increasing speeds—press up to four times. |
| ERE/SINMI | Plays the current program. Press once while the program is playing to PAUSE. |
| DASH (-) | Press for Guide Options while viewing On-Screen Guide. Press for playlist options while viewing playlist. Press to display last 6 digits of receiver ID, satellite signal type (SWiM or Multiswitch) and Internet status. |
| ADURA | Advances 30 seconds. Press and hold to jump ahead to the end of a recorded program. |
| SÁYERE-Siwaju | Fast-forwards at increasing speeds—press up to four times. |
| ENTER (Input) | Press for Mini Guide while viewing your program and dismiss with EXIT. ENTER also replaces TV INPUT button: to cycle through the equipment connected to your TV, press and hold for three seconds until LED light at top turns green. Then scroll through inputs by pressing ENTER again. |
Itoju
Batiri Rirọpo
When the remote's performance degrades or the green light no longer blinks during operation, it's time to replace the batteries. Always use two new AA batteries for optimal performance.
- Remove the battery compartment cover as described in the Setup section.
- Yọ awọn batiri atijọ kuro.
- Insert two new AA batteries, observing the correct polarity (+/-).
- Rọpo ideri iyẹwu batiri.
Ninu
To maintain the remote's appearance and functionality, periodically wipe it with a soft, dry cloth. Avoid using abrasive cleaners, solvents, or harsh chemicals, as these can damage the remote's surface or internal components.
Laasigbotitusita
| Oro | Owun to le Fa | Ojutu |
|---|---|---|
| Remote not responding to receiver. | Low or dead batteries; Remote not paired in RF mode; Obstruction between remote and receiver (if in IR mode). | Replace batteries. Ensure remote is paired in RF mode (refer to Setup section). Remove any obstructions. |
| Volume or TV power buttons not working. | Remote not programmed to TV. | Program the remote to your TV (refer to Setup section, "Programming the Remote to Your TV"). |
| Green light on remote blinks slowly or not at all. | Agbara batiri kekere. | Rọpo awọn batiri lẹsẹkẹsẹ. |
| Remote controls receiver but not client device (e.g., Genie Mini). | Client device not properly paired or connected. | Ensure the client device is correctly connected and powered on. Re-pair the remote with the client device if necessary (consult your Genie Mini's specific instructions). |
Awọn pato
- Brand: DIRECTV
- Awoṣe: RC73
- Nọmba Awoṣe Nkan: 4336303112
- Imọ-ẹrọ Asopọmọra: Infrared (IR), Radio Frequency (RF)
- Awọn ẹrọ ibaramu: DIRECTV Genie (HR44 or above), Genie Lite (H44 or above), Genie Mini (C41 or above), 4K Genie Mini (C61K or above), Wireless Genie Mini (C41W or above) in RF mode. All DIRECTV receivers and DIRECTV Ready TVs in IR mode.
- Orisun Agbara: Awọn batiri AA 2 (pẹlu)
- Ìwọ̀n Nkan: 1 iwon
- Awọn iwọn idii: 9.61 x 3.7 x 2.91 inches
- Àwọ̀: Dudu
- Ẹya Pataki: Original DirecTV Equipment
Atilẹyin ọja ati Support
For specific warranty information regarding your DIRECTV RC73 remote control, please refer to the documentation included with your original purchase or visit the official DIRECTV webojula. Awọn ofin atilẹyin ọja le yatọ.
For technical support, troubleshooting assistance beyond this manual, or to inquire about replacement parts, please contact DIRECTV customer service directly. Contact information can typically be found on your DIRECTV bill, their official website, or through your service provider.
Awọn orisun Ayelujara:
- Official DIRECTV Webojula: www.directv.com
- Support Pages: Look for a "Support" or "Help" section on the DIRECTV website for FAQs and additional guides.
Awọn iwe aṣẹ ti o jọmọ - RC73, 4336303112
 |
Ìtọ́sọ́nà DIRECTV Genie àti Ìtọ́sọ́nà Ìṣàkóso Lílo Agbára Gbogbogbòò Ìtọ́sọ́nà pípéye láti lóye iṣẹ́ DIRECTV Genie àti àwọn remote Universal, pẹ̀lú àlàyé kíkún lórí bọ́tìnì àti ìlànà ètò fún onírúurú àwọn olugba DIRECTV àti TV. |
 |
DIRECTV Alailowaya Ẹmi Mini Oṣo ati Itọsọna Muu ṣiṣẹ Awọn ilana igbesẹ-nipasẹ-igbesẹ fun sisopọ, iṣeto, muṣiṣẹ, ati siseto DIRECTV Alailowaya Genie Mini tuntun rẹ fun ere idaraya fidio alailẹgbẹ. |
 |
Itọsọna Iṣakoso Latọna jijin Gbogbogbo DIRECTV: Bibẹrẹ ati Ṣiṣẹda Eto Kọ́ bí a ṣe lè lo DIRECTV gbogbogbòò ìṣàkóso latọna jijin rẹ, lóye àwọn iṣẹ́ bọ́tìnì, kí o sì ṣètò ìṣàkóso latọna jijin RC73 rẹ fún àwọn àkọọ́lẹ̀ ìṣòwò. Ó ní àwọn ìtọ́ni àti àwọn ẹ̀yà ara rẹ̀ nínú. |
 |
DIRECTV Genie 2 Ṣiṣẹ olupin ati Awọn ilana Ipadabọ Awọn ohun elo Itọsọna igbese-nipasẹ-igbesẹ fun ṣiṣiṣẹ rirọpo rẹ DIRECTV Genie 2 Server ati ipadabọ ohun elo atijọ rẹ lati yago fun awọn idiyele ti kii ṣe ipadabọ. Pẹlu iṣeto, sisopọ, ati awọn ilana ipadabọ. |
 |
Ìwé Ìtọ́sọ́nà Ọjà DIRECTV Genie 2 - Àwọn Ẹ̀yà Ara Rẹ̀, Àwọn Ìlànà Pàtàkì, àti Ìwífún Nípa Ààbò Ìwé ìtọ́ni ọjà tó péye fún DIRECTV Genie 2 satẹlaiti receiver, tó ní àwọn àlàyé ẹ̀rọ, àwọn ẹ̀yà ara ẹ̀rọ, ìṣòro, àwọn àmì LED, àwọn ìṣọ́ra ààbò, àti ìwífún nípa àtìlẹ́yìn. Ó ní ìṣètò àti ìtọ́sọ́nà iṣẹ́. |
 |
DIRECTV Wireless Genie Mini C41W Installation Guide Step-by-step guide to installing and connecting the DIRECTV Wireless Genie Mini (Model C41W) to your Genie HD DVR for enhanced home entertainment. |