ÀTẸ̀JÁDE Ìṣàkóso Latọna jijin Gbogbogbòò EDI-RCU 1 ​​Kọ́ Ìtọ́ni Ìtọ́ni

1. Ifihan ati Loriview

The EDISION EDI-RCU 1 Learn is a versatile 2-in-1 infrared universal remote control designed for seamless operation of your EDISION receiver and television. This remote comes pre-programmed for common TV functions and offers a learning function to customize control for most TV systems. It is an original replacement remote control, ensuring compatibility and reliable performance.

Aworan 1.1: Iwaju view of the EDISION EDI-RCU 1 Learn Universal Remote Control.

2. Awọn ẹya Ọja

• 2-in-1 Iṣẹ-ṣiṣe: Controls both your EDISION receiver and television.
• Iṣẹ ikẹkọ: Allows individual programming of TV functions from your original TV remote.
• Pre-programmed TV Types: Compatible with 4 common pre-programmed TV types (e.g., Samsung, LG).
• Wide EDISION Receiver Compatibility: Supports various EDISION receiver models.
• Asopọmọra infurarẹẹdi: Standard IR signal transmission.
• Apẹrẹ Ergonomic: Itura lati mu ati lo.

Image 2.1: The remote control held in hand, illustrating its dimensions (15 cm length, 4.2 cm width) and key features.

3. Eto: Fifi sori batiri

The EDISION EDI-RCU 1 Learn remote control requires two AAA batteries (not included) for operation. Follow these steps to install the batteries:

1. Wa ideri iyẹwu batiri ni ẹhin isakoṣo latọna jijin.
2. Slide the cover downwards or press the latch (if present) and lift to open the compartment.
3. Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals match the polarity indicators inside the compartment.
4. Rọpo ideri iyẹwu batiri nipa gbigbe pada si aaye titi yoo fi tẹ ni aabo.

Important: Always use new batteries and dispose of old batteries responsibly. Do not mix old and new batteries or different types of batteries.

Aworan 3.1: Iwaju ati sẹhin views of the remote control, showing the battery compartment requiring 2 x AAA batteries.

4. Operating Instructions: Programming TV Functions

The EDI-RCU 1 Learn remote control is designed to operate your EDISION receiver directly. Additionally, it features a learning function to program essential TV controls (ON/OFF, TV/AV, Volume Up, Volume Down) from your original TV remote control.

4.1. Programming TV Buttons (Learning Function)

This process allows you to copy specific functions from your original TV remote to the designated TV control buttons on the EDI-RCU 1 Learn remote. The TV control section is located at the top right of the remote, highlighted in the image below.

Image 4.1: The EDI-RCU 1 Learn remote control, with the TV control buttons (Power, TV/AV, SET, VOL+, VOL-) highlighted for programming.

1. Tẹ Ipo Ẹkọ sii: Tẹ mọlẹ SET button (located in the upper right TV control area) for approximately 4 seconds. The indicator light (usually red) on the remote will turn on and remain steady, indicating it is ready to learn. Release the SET bọtini.
2. Yan Bọtini lati Ètò: Within 10 seconds, press the button on the EDI-RCU 1 Learn remote that you wish to program (e.g., the ON/OFF [TV Power Button]). The indicator light will flash once and then remain steady, signifying it is ready to receive a signal.
3. Transmit Signal from Original Remote: Point the infrared "eye" of your original TV remote control directly at the infrared "eye" of the EDI-RCU 1 Learn remote (typically located at the top of both remotes) at a distance of 2-3 cm.
4. Press Original Remote Button: Press and hold the corresponding button on your original TV remote (e.g., the Power button) for about 3 seconds.
5. Ìmúdájú: If the learning process is successful, the indicator light on the EDI-RCU 1 Learn remote will flash three times quickly and then turn off. This confirms the function has been saved.
6. Repeat for Other Functions: Repeat steps 2-5 for the remaining TV functions you wish to program: TV/AV (to switch between TV/AV modes), VOL+ (Volume Up), and VOL- (Volume Down).
7. Jáde Ipò Ẹ̀kọ́: After programming all desired buttons, press the SET button again to exit learning mode. The indicator light will turn off.

Troubleshooting Tip: If the indicator light flashes and then immediately turns off without flashing three times, the learning process failed. Repeat the steps carefully, ensuring proper alignment and sufficient distance between the remotes.

5. Ibamu

The EDISION EDI-RCU 1 Learn remote control is compatible with a wide range of EDISION receivers and can be programmed to control most TV systems. Below is a list of compatible EDISION receiver models:

• Picco T2, Picco T265, Picco T265+, Picco T265 Pro
• Nano T265+, Nano T265+ LED
• Proton S2, Proton T265, Proton T265 LED
• Picco S2, Picco Cable
• Progressive Nano, Progressive Nano Plus, Progressive Nano Plus LED
• Hybrid, Hybrid Lite, Hybrid Lite LED
• Triton T2
• Piccollino S2, Piccollino S2+T2/C
• Piccollo S2+T2/C
• PING, PING T2/C, PING S2+T2/C

For a visual representation of compatibility with various EDISION models, please refer to the compatibility chart below:

Image 5.1: Compatibility chart showing which EDISION models are supported by EDI-RCU 1 Learn and other EDI-RCU remotes.

6. Awọn pato

7. Laasigbotitusita

If you encounter issues with your EDISION EDI-RCU 1 Learn remote control, consider the following:

• Ko si Idahun: Ensure batteries are correctly inserted with the correct polarity and are not depleted. Replace batteries if necessary.
• Remote Not Controlling Device: Ensure there is a clear line of sight between the remote's IR emitter and the device's IR receiver. Obstructions can block the signal.
• TV Functions Not Working: If TV functions were programmed using the learning function, repeat the programming steps (Section 4.1) carefully. Ensure the original remote's signal is strong and correctly transmitted.
• Ibi to lopin: Weak batteries can reduce the remote's effective range. Replace batteries if the range is significantly reduced.

8. Itọju

Láti rí i dájú pé ìṣàkóso latọna jijin rẹ pẹ́ tó àti pé ó ń ṣiṣẹ́ dáadáa:

• Ninu: Mu ese isakoṣo latọna jijin kuro pẹlu asọ ti o gbẹ. Ma ṣe lo awọn olutọpa omi tabi awọn ohun elo abrasive.
• Rirọpo Batiri: Replace batteries promptly when they are depleted. Remove batteries if the remote will not be used for an extended period to prevent leakage.
• Ibi ipamọ: Tọju isakoṣo latọna jijin ni aaye gbigbẹ, kuro lati orun taara ati awọn iwọn otutu to gaju.
• Yago fun awọn isọ silẹ: Dáàbò bo latọna jijin kuro ninu ipa ti ara, nitori awọn ẹya inu le bajẹ.

9. Atilẹyin ọja ati Support

Fun alaye atilẹyin ọja tabi atilẹyin imọ ẹrọ, jọwọ kan si alagbata rẹ tabi olupese taara. Tọju iwe-ẹri rira rẹ bi ẹri rira.

Manufacturer: EDISION HELLAS LTD

Webojula: www.edisi.gr

Image 9.1: Barcode (UPC: 5200378400562) and manufacturer details for EDISION HELLAS LTD.