Tunse 6040.005

Tunze Turbelle NanoStream 6040.005 HUB Edition Instruction Manual

Awoṣe: 6040.005

1. Ifihan

This manual provides detailed instructions for the installation, operation, and maintenance of your Tunze Turbelle NanoStream 6040.005 HUB Edition. This high-performance stream pump is designed for aquariums ranging from 20 to 500 liters (5.3 to 132 USgal.), offering adjustable flow rates and smart control capabilities.

The Turbelle NanoStream 6040.005 HUB Edition is equipped with a WIFI/Cloud-based controller (Turbelle Controller 7020) for precise flow management and features a compact design for easy integration into your aquarium.

2. Awọn ilana aabo

  • Always disconnect the power supply before performing any maintenance or installation work on the pump.
  • Ensure the power supply unit is placed in a dry area, away from water splashes.
  • Do not operate the pump if the power cord or any part of the unit is damaged.
  • This device is intended for indoor use only and for aquariums.
  • Jeki kuro ni arọwọto awọn ọmọde.
  • The pump must be fully submerged during operation.

3. Package Awọn akoonu

Jọwọ ṣayẹwo pe gbogbo awọn nkan wa ninu package:

  • Tunze Turbelle NanoStream 6040.005 Pump
  • Turbelle Controller 7020 (WIFI/Cloud-based)
  • Power Supply Unit (100-240V / 50-60Hz)
  • Magnet Holder (for glass thickness up to 12 mm / 1/2”)
  • Sisan Deflector
  • Ilana itọnisọna

4. Eto ati fifi sori

Follow these steps to properly install your Turbelle NanoStream 6040.005 pump:

4.1. Positioning the Pump

Tunze Turbelle NanoStream 6040.005 pump mounted on aquarium glass with magnet holder

Image: The Turbelle NanoStream 6040.005 pump securely mounted to the aquarium glass using its magnet holder.

  • Yan Ibi: Select a position in your aquarium where the pump can create optimal water flow without disturbing substrate or corals excessively. Ensure the pump is fully submerged.
  • Attach Magnet Holder: Place the pump unit inside the aquarium and align the external magnet holder on the outside of the glass. The strong magnets will secure the pump in place. The magnet holder is suitable for glass thicknesses up to 12 mm (1/2 inch).
  • Ṣatunṣe Itọsọna: The pump's outlet can be rotated to direct the water flow as desired.

4.2. Nsopọ Adarí

Tunze Turbelle Controller 7020 with various buttons and display for flow control

Image: The Tunze Turbelle Controller 7020, showing its interface for adjusting pump settings and modes.

  • Connect Pump to Controller: Plug the pump's cable into the designated port on the Turbelle Controller 7020.
  • Sopọ Ipese Agbara: Plug the power supply unit into the controller, then plug the power supply into a suitable electrical outlet.
  • Agbara Ibẹrẹ: The pump will perform a brief self-test upon initial power-up.

5. Awọn ilana Iṣiṣẹ

The Turbelle NanoStream 6040.005 is controlled via the Turbelle Controller 7020, offering various modes and settings.

5.1. Adarí Loriview

Tunze Turbelle Controller 7020 with buttons for Food Timer, Manual, Cloud, Analog, Mode, Wave Search, Min Power, Pulse Duration, Max Power

Aworan: Alaye view of the Tunze Turbelle Controller 7020, highlighting its control functions.

The controller allows you to adjust flow rate, set wave patterns, and utilize special functions like the food timer.

5.2. Ipilẹ isẹ

  • Aṣayan Ipo: Use the "Mode" button to cycle through different operating modes (e.g., Constant, Pulse, Wave).
  • Atunse Sisan: Use the "+" and "-" buttons to increase or decrease the flow rate in Constant mode, or to adjust pulse intensity/duration in other modes.
  • Food Timer: Press the "Food Timer" button to temporarily stop the pump for approximately 10 minutes, allowing fish to feed undisturbed. The pump will automatically resume operation after the timer expires.
  • Wave Search: The "Wave Search" function helps to find the optimal wave frequency for your aquarium.

5.3. WIFI/Cloud Control

The HUB Edition features WIFI/Cloud-based control. Refer to the separate Tunze app manual for detailed instructions on connecting your controller to your home network and managing it remotely via the cloud.

6. Itọju

Regular maintenance ensures optimal performance and longevity of your Turbelle NanoStream pump.

6.1. Cleaning the Pump

Tunze Turbelle NanoStream 6040.005 pump disassembled for cleaning, showing impeller and housing

Image: The Turbelle NanoStream 6040.005 pump, illustrating its components for easy disassembly and cleaning.

  • Ge Agbara: Always unplug the pump from the power outlet before cleaning.
  • Yọ kuro ninu Aquarium: Carefully remove the pump from the aquarium.
  • Tutu: Gently detach the flow deflector and the protective cage. The impeller can then be carefully removed.
  • Awọn ohun elo mimọ: Use a soft brush and warm water to remove algae, calcium deposits, and other debris from all pump components, especially the impeller and its housing. For stubborn deposits, a mild vinegar solution can be used, followed by thorough rinsing.
  • Ṣe atunto: Reassemble the pump in reverse order, ensuring all parts are correctly seated.
  • Igbohunsafẹfẹ: Clean the pump every 1-3 months, depending on the amount of debris and algae in your aquarium.

6.2. Àyẹ̀wò okùn

Periodically inspect the power cable for any signs of wear, cuts, or damage. If any damage is found, discontinue use immediately and contact Tunze support.

7. Laasigbotitusita

Eyi ni diẹ ninu awọn ọran ti o wọpọ ati awọn ojutu wọn:

IsoroOwun to le FaOjutu
Pump not starting or weak flow.
  • Ko si ipese agbara.
  • Impeller blocked by debris.
  • Air trapped in the pump.
  • Controller settings too low.
  • Ṣayẹwo awọn asopọ agbara.
  • Disconnect power, remove pump, clean impeller and housing.
  • Gently shake the pump while submerged to release air.
  • Increase flow setting on the controller.
Pump making unusual noise.
  • Impeller dirty or damaged.
  • Pọ́ọ̀pù náà kò ní omi pátápátá.
  • Vibrations against aquarium glass.
  • Clean or inspect impeller for damage. Replace if necessary.
  • Ensure pump is fully submerged.
  • Adjust pump position or use the included Silence Clamp (if applicable) to reduce vibrations.
Oluṣakoso ko dahun.
  • Ipese agbara oro.
  • Aṣiṣe oludari.
  • Check power connections to the controller.
  • Try resetting the controller by unplugging and replugging the power. If issues persist, contact support.

8. Awọn pato

AwoṣeTunze Turbelle NanoStream 6040.005 HUB Edition
Nọmba Awoṣe Nkan (Inu)6095.005
Iwọn Akueriomu20 to 500 liters (5.3 to 132 USgal.)
Oṣuwọn sisanApprox. 200 to 4,500 l/h (53 to 1,190 USgal./h)
Lilo Agbara1.5 - 13 W
Agbara Ipese Unit100-240V / 50-60Hz
USB Ipari3 m (118")
Dimensions (without flow deflector and Magnet Holder)60 x 43 x 68 mm (2.36 x 1.69 x 2.68 in.)
Iwọn opin iṣanø40 mm (1.57”)
Magnet Holder Glass ThicknessUp to 12 mm (1/2”)
Ohun eloṢiṣu
Àwọ̀Black/Blue/White
Iwọn Nkan2.75 iwon

9. Atilẹyin ọja

The Tunze Turbelle NanoStream 6040.005 HUB Edition comes with a 5-odun atilẹyin ọja from the date of purchase. This warranty covers manufacturing defects and material faults under normal use conditions. Please retain your proof of purchase for warranty claims. The warranty does not cover damage caused by improper installation, misuse, neglect, or unauthorized modifications.

10. Atilẹyin ati Alaye olubasọrọ

For further assistance, technical support, or warranty inquiries, please contact Tunze customer service or visit the official Tunze webojula.

Atilẹyin Ayelujara: Visit the Tunze Store on Amazon

Jọ̀wọ́ mú nọ́mbà àwòṣe ọjà rẹ (6040.005) àti ọjọ́ tí o fẹ́ ra ọjà náà ti ṣetán nígbà tí o bá ń bá olùrànlọ́wọ́ sọ̀rọ̀.

Awọn iwe aṣẹ ti o jọmọ - 6040.005

Ṣaajuview TUNZE ORCA MK2, Turbelle nanostream, Turbelle stream - Aquarium Circulation Pumps User Manual
Comprehensive user manual for TUNZE ORCA MK2, Turbelle nanostream, and Turbelle stream aquarium circulation pumps. Includes safety instructions, product features, technical specifications, installation guides, and troubleshooting.
Ṣaajuview Awọn ifasoke Akueriomu ṣiṣan TUNZE Turbelle - Awọn ilana fun Lilo & Awọn pato Imọ-ẹrọ
Iwe yii pese awọn itọnisọna fun lilo, awọn alaye imọ-ẹrọ, ati alaye ailewu fun awọn ifasoke aquarium ṣiṣan TUNZE Turbelle, pẹlu awọn awoṣe 6065, 6085, 6125, 6105 eco, ati 6255 eco, pẹlu TUNZE HUB Adarí 7020.
Ṣaajuview TUNZE DOC Skimmer 9430 DC Olumulo Itọsọna ati Imọ-ẹrọ
Iwe-ipamọ yii n pese awọn itọnisọna okeerẹ fun TUNZE DOC Skimmer 9430 DC, ti o bo awọn ẹya ara ẹrọ rẹ, fifi sori ẹrọ, iṣẹ ṣiṣe, itọju, awọn itọnisọna ailewu, ati awọn alaye imọ-ẹrọ fun awọn aquariums omi iyọ.
Ṣaajuview TUNZE Turbelle stream Aquarium Pumps: Instructions and Technical Data
Explore the TUNZE Turbelle stream series of aquarium circulation pumps (models 6065, 6085, 6125, 6105 eco, 6255 eco). This comprehensive manual details setup, operation, technical specifications, safety guidelines, and advanced features like Fish Care and controller integration for optimal aquarium water management.
Ṣaajuview TUNZE Turbelle High Jet 5000.021 Pump - Afọwọṣe olumulo ati Awọn pato Imọ-ẹrọ
Awọn itọnisọna okeerẹ fun TUNZE Turbelle High Jet 5000.021 kaakiri ati fifa iwọn lilo, iṣeto ibora, iṣẹ ṣiṣe, ailewu, itọju, ati data imọ-ẹrọ.
Ṣaajuview TUNZE SmartController 7000.001 Instructions for Use
User manual and technical specifications for the TUNZE SmartController 7000.001, an aquarium controller for managing devices and monitoring parameters like temperature, pH, and redox. Includes setup, functions, maintenance, and warranty information.