M5STACK Unit C6L Ni oye eti Computing Unit ká Afowoyi

M5STACK Unit C6L Ni oye eti Computing Unit ká Afowoyi

Unit C6L is an intelligent edge computing unit integrated with the M5Stack_Lora_C6module — featuring an Espressif ESP32-C6 SoC and Semtech SX1262 LoRa transceiver — and engineered with a modular design for long-range, low-power LoRaWAN communication alongside high-speed 2.4 GHz Wi-Fi and BLE connectivity.
It includes a 0.66″ SPI OLED display for real-time data visualization, a WS2812Caddressable RGB LED for system-status indication, a built-in buzzer for audible alerts, and front-panel buttons (SYS_SW) with a reset switch for local interaction. Astandard Grove I²C interface allows seamless integration with M5Stack hosts and various Grove sensors. The onboard USB Type-C port supports ESP32- C6 firmware programming, serial debugging, and 5 V power input, while automatic power switching and multi-channel ESD/surge protection ensure stable operation. Unit C6L excels at real-time data acquisition, edge-intelligence processing, and remote control, making it ideal for IoT applications such as smart agriculture, environmental monitoring, industrial IoT, smart buildings, asset tracking, and urban infrastructure sensing.\

1.1. Ẹka C6L

1. Awọn agbara ibaraẹnisọrọ
   Integrated LoRa (Semtech SX1262), supporting LoRaWAN Class A/B/Candpointto-point modes 2.4 GHz Wi-Fi and BLE via ESP32-C6-MINI-1U
2. isise & Performance
   Main Controller: Espressif ESP32-C6 (single-core RISC-V, up to 40 MHz) On-chip Memory: 512 KB SRAM with integrated ROM
3. Agbara & Isakoso Agbara
   Power Input: USB Type-C (5 V input) and Grove 5 V input
4. Ifihan & Awọn itọkasi
   0.66″ SPI OLED display for real-time data visualization and status monitoringWS2812C addressable RGB LED for system-status indication Built-in buzzer for audible alerts
5. Interfaces & Controls
   Grove I²C interface (with 5 V power) for seamless connection to M5Stack hostsandGrove sensors USB Type-C port for firmware programming, serial debugging, and power input Front-panel buttons (SYS_SW) and reset switch (MCU_RST) for local control
6. Expansion & Debug Pads
   Bootloader pad: predefined jumper pad for entering bootloader mode Test points (TP1–TP8) for signal probing and in-circuit debug

2. AWỌN NIPA

Paramita	Sipesifikesonu
MCU	Espressif ESP32-C6(RISC-V mojuto-ọkan, to 40 MHz)
Ibaraẹnisọrọ	LoRaWAN; 2.4 GHz Wi-Fi BLE
Agbara Input	USB Iru-C (5V) ati Grove 5V
Ipese Voltage	3.3 V (lori-ọkọ LDO)
Filaṣi Ibi ipamọ	16 MB SPI Filaṣi (128 Mbit)
Ifihan	0.66”SPI OLED(128×64)
Atọka	WS2812C adirẹẹsi RGB LED
Buzzer	Lori-ọkọ buzzer
Awọn bọtini	System button (SYS_SW)and reset button(MCU_RST)
Awọn atọkun	Grove I²C; USB Iru-C; paadi bootloader; awọn paadi yokokoro TP1-TP8
Eriali	2×SSMB-JEF clamp awọn asopọ; 2× IPEX-4 awọn asopọ eriali
Awọn iwọn otutu ti nṣiṣẹ	Awọn iwọn otutu ti nṣiṣẹ
Afikun Awọn ẹya ara ẹrọ	Multi-channel ESD/surge protection
Olupese	M5Stack Technology Co., Ltd Block A10, Expo Bay South Coast, Fuhai Street, Bao’an District, Shenzhen, China
Frequency Range for CE	2.4G Wi-Fi: 2412-2472MHz BLE: 2402-2480MHz Lora: 868-868.6MHz
Iye ti o ga julọ ti EIRP fun CE	BLE: 5.03dBm 2.4G Wi-Fi: 16.96dBm Lora: 9.45dBm
Ẹka olugba	The equipment provider declared that the receiver category for the EUTis2.

3. FCC Ikilọ

Iṣọra FCC:
Eyikeyi awọn iyipada tabi awọn iyipada ti ko fọwọsi ni pato nipasẹ ẹgbẹ ti o ni iduro fun ibamu le sọ aṣẹ olumulo di ofo lati ṣiṣẹ ohun elo naa. Ẹrọ yii ni ibamu pẹlu apakan 15 ti Awọn ofin FCC. Isẹ jẹ koko ọrọ si awọn ipo meji wọnyi: (1) Ẹrọ yii le ma fa kikọlu ipalara, ati (2) ẹrọ yii gbọdọ gba kikọlu eyikeyi ti o gba, pẹlu kikọlu ti o le fa iṣẹ ti ko fẹ.
AKIYESI PATAKI:
Akiyesi: This equipment has been tested and found to comply with the limits for a ClassBdigital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
ṣe atunṣe kikọlu nipasẹ ọkan tabi diẹ ẹ sii ti awọn iwọn wọnyi:

• Reorient tabi tun eriali gbigba pada.
• Increase the separation betweentheequipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator&your body.

I. Installing Arduino IDE(https://www.arduino.cc/en/Main/Software)
Tẹ lati ṣabẹwo si osise Arduino webojula, ki o si yan awọn fifi sori package fun nyin
operating system to download. Ⅱ. Installing Arduino Board Management
1. The Board Manager URL is used to index the development board information for specific platform. In the Arduino IDE menu, select File -> Awọn ayanfẹ

2.Daakọ iṣakoso igbimọ ESP URL ni isalẹ sinu Afikun Board Manager
URLs: field, and save.
https://espressif.github.io/arduino-esp32/package_esp32_dev_index.json

3. Ni awọn legbe, yan Board Manager, wa fun ESP, ki o si tẹ Fi.

4. Ni awọn legbe, yan Board Manager, wa fun M5Stack, ki o si tẹ Fi.
Depending on the product used, select the corresponding development board under
Tools -> Board -> M5Stack -> {ESP32C6 DEV Module board}.

5. So awọn ẹrọ si kọmputa rẹ pẹlu a data USB lati po si awọn eto

Awọn iwe aṣẹ / Awọn orisun

M5STACK Unit C6L Ni oye eti Computing Unit [pdf] Afọwọkọ eni M5UNITC6L, 2AN3WM5UNITC6L, Unit C6L Intelligent Edge Computing Unit, Unit C6L, Intelligent Edge Computing Unit, Edge Computing Unit, Computing Unit, Unit

Awọn itọkasi

• Itọsọna olumulo